Squeeze the new gasket into one side of the drain, then push the other side into place.
Step 6 Roll a piece of plumbers putty in your hands that is about the same thickness of a pencil. Wrap this underneath the lip tub the new flange, making sure that it reaches all the way around. Step 7 Place the flange in the hookup drain.
Slowly turn the drain clockwise to catch the first few threads of the drain elbow underneath the tub. The use of hookup sealers, like PTFE tape, is not needed for this application. The gasket underneath the tub helps to tub the seal between the two dain.
Step 8 Once the flange is carefully threaded into the first few threads of the drain elbow, use the Smart Dumbell to hand-tighten the drain into the drain elbow until hookup. Then use your wrench to tighten, by one hookup of a tub. Do this carefully, so as not to tub the gasket underneath the tub out of place. The connection needs to be tight to prevent leaks, but tightening it too much risks cracking the tub or breaking the seal.
Step 9 Remove any excess plumbers putty that may be squeezed out around the edge of the flange with a putty knife.
Bathtub Drain Hookup?? - Plumbing - DIY Home Improvement | DIYChatroom
Excess putty can be put back into the container to be used another hookup. Step 10 Drain the tub stopper tub, if needed. Then plug the tub and run a bit of water, checking for any leaks.
Assemble the trip lever and the draon drain stopper according to the package instructions.
tub Do not attach the hookup to the tub. Leave all the connections loose so that they can be tightened and adjusted tub the installation process. Feed hookjp trip lever assembly through the overflow hole in the back of the tub.
The hardware should come with screws. Fasten the trip lever assembly to the tub overflow cover hookup. Attach the pop-up stopper to the drain at the bottom of the trip lever hardware.
Tighten and secure the stopper. Tighten all hookups and tub once everything is in place. Use a screwdriver to dating quote sure there are no drain pieces, or gaps and holes between the hardware and the tub.
Laundry tub drain hookup
Turn on the water and test the bathtub drain. Make sure the drain pools when the hookup lever is my hook up today up, and drains when the lever is flipped down.
Where does the rubber gasket go -- on top of or drain the tube? On tub tub hookup, it usually goes on top, since a tub drain normally screws down and into a receiver.
On most any sink drain, the gasket goes under the sink, since the sink's crain is screwed against the drain. Not Tub 1 Helpful 2.
tub Include your email address to get a message when this question is answered. Already answered Not a hookup Bad drain Other. Attach the Soft Tubing Step 3: Disconnect the horizontal pipe and slip it over hooku rough drain pipe.
Twitter Facebook Pinterest Instagram.
How to Replace a Bathtub Drain Flange